Published at Monday, March 25th, 2019 - 13:31:29 PM. wiring. By Georgitte Lecomte.
The first things we need to do are check the compressor electrically and make sure it is safe to start; after making sure the compressor is safe to start, we need to reconnect it and see if it will start — the start assist (PTC) device may be defective; and when and if the compressor starts, we need to give the system a thorough check up to see why the technician was even doing what he was doing to cause him to disconnect the compressor,” Bob replied. “How can we make sure the compressor is safe to start?” Tim asked. “We want to make sure that it is safe to apply power to the terminals, Bob said. ”Use the Ohmmeter set on RX10K (10,000 Ohms). Second, fasten one lead to a good ground, scrape any scale or paint off the suction line, for example, and firmly hold the lead to the bare spot. Then, touch the other lead to one of the compressor terminals and record any reading. There should not be a reading. If there is a reading, the compressor has a ground circuit in the compressor. A circuit from the motor windings to ground. ”To illustrate how your meter works, you should be able to read a slight reading through your body if you hold one lead in each hand,” Bob continued. ”
How do you do this? How do you do this? Glad you asked: We covered this before in “Preparing Your Tele for Future Mods.” If you have a Strat pickup, a P-90, or some similar single-coil in the neck position, you can skip this step. For all other pickups sporting a metal cover that’s connected to the pickup’s ground, you’ll need to break this connection before you proceed. It Shows the wiring, which looks familiar but is a little bit more complex than standard Telecaster’s wiring. The important detail here is to connect the hot wire from the neck pickup to the volume pot’s input lug, rather than directly to the switch, which is the usual approach. There are other ways to accomplish the mod, but this is my favorite method because it’s simple to wire and you can easily reverse the mod or upgrade to a 4-way switching system at a later date. And the beauty of this is we still have the familiar operation of a standard Telecaster 3-way selector. The only change is the new sound for the middle position; the other two settings are not affected. Also, you can incorporate other mods into this wiring, such as the ’50s wiring that I’ve covered before.
Any content, trademark’s, or other material that might be found on the Eventionline website that is not Eventionline’s property remains the copyright of its respective owner/s. In no way does Eventionline claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.