Published at Tuesday, March 26th, 2019 - 06:06:41 AM. wiring. By Romana Maurice.
But you can also choose a more radical configuration. For instance, how about a very small 6800 pF silver mica cap for the bridge pickup—thus converting the bridge tone pot into a “warmth control” that will yield a super-sharp, contoured solo sound—in combination with a 0.033 µF paper-in-oil cap for the neck pickup. The latter would let you dial in deep, classic jazz tones or a warm rhythm sound. You can have a lot of fun experimenting to find a combination that works best for you. Another benefit of this wiring is its “preset” function. You can dial in two completely different tones, as in the example above, and engage either with only a flip of the 3-way pickup selector switch.
“How can we make sure the compressor is safe to start?” Tim asked. “We want to make sure that it is safe to apply power to the terminals,” Bob said. ”Use the Ohmmeter set on RX10K (10,000 Ohms). Second, fasten one lead to a good ground, scrape any scale or paint off the suction line, for example, and firmly hold the lead to the bare spot. Then, touch the other lead to one of the compressor terminals and record any reading. There should not be a reading. If there is a reading, the compressor has a ground circuit in the compressor. A circuit from the motor windings to ground. ”To illustrate how your meter works, you should be able to read a slight reading through your body if you hold one lead in each hand,” Bob continued.
Any content, trademark’s, or other material that might be found on the Eventionline website that is not Eventionline’s property remains the copyright of its respective owner/s. In no way does Eventionline claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.